Filter
Top Products
9-14
Cisco ONS 15454 Installation and Operations Guide
November 2001
Chapter 9 Ethernet Operation
Ethernet Circuit Configurations
9.3.3 Hub and Spoke Ethernet Circuit Provisioning
This section provides steps for creating a hub and spoke Ethernet circuit configuration. The hub and
spoke configuration connects point-to-point circuits (the spokes) to an aggregation point (the hub). In
many cases, the hub links to a high-speed connection and the spokes are Ethernet cards. Figure 9-14
illustrates a sample hub and spoke ring. Your network architecture may differ from the example.
Figure 9-14 A Hub and Spoke Ethernet circuit
Procedure: Provision a Hub and Spoke Ethernet Circuit
Step 1 Display CTC for one of the ONS 15454 Ethernet circuit endpoints.
Step 2 Double-click the Ethernet card that will create the circuit.
Step 3 Click the Provisioning > Card tabs.
Step 4 Under Card Mode, check the Single-card EtherSwitch checkbox.
If Single-card EtherSwitch is not checked, check it and click Apply.
Step 5 Navigate to the other ONS 15454 endpoint and repeat Steps 2 – 4.
Step 6 Display the node view or network view.
Step 7 Click the Circuits tab and click Create.
The Circuit Creation (Circuit Attributes) dialog box opens (Figure 9-7 on page 9-8).
Step 8 In the Name field, type a name for the circuit.
Step 9 From the Type pull-down menu, choose STS.
Note The types VT and VT Tunnel do not apply to Ethernet circuits.
Step 10 Choose the size of the circuit from the Size pull-down menu.
Step 11 Verify that the Bidirectional checkbox is checked and click Next.
The Circuit Creation (Circuit Source) dialog box opens.
43386
ONS 15454
#1
ONS 15454
#2
192.168.1.25
255.255.255.0
VLAN test
192.168.1.50
255.255.255.0
VLAN test
192.168.1.125
255.255.255.0
VLAN test
192.168.1.75
255.255.255.0
VLAN test
192.168.1.100
255.255.255.0
VLAN test
ONS 15454
#3