Filter
Top Products
1-56
Cisco ONS 15454 Installation and Operations Guide
November 2001
Chapter 1 Hardware Installation
Cable Routing and Management
Figure 1-34 Routing fiber-optic cables on the optical-card faceplate
Procedure: Route Fiber-Optic Cables in the Shelf Assembly
Step 1 Open the fold-down front door on the cable-management tray.
Step 2 Route the cable on the card faceplate through the fiber clip on the faceplate.
GBICs do not have fiber clips; therefore, if you are routing optical cable from an E1000-2-G or E1000-2
card, skip to Step 3.
Step 3 Route the cables into the cable-management tray.
Step 4 Route the cables out either side of the cable-management tray through the cutouts on each side of the
shelf assembly. Use the reversible fiber guides to route cables out the desired side.
Step 5 Close the fold-down front door when all cables in the front compartment are properly routed.
Figure 1-35 shows the fold-down front door of the shelf assembly open to display the cable routing
channel.
Tx
Rx
FAIL
ACT
SF
Fold down faceplate
Retaining clip
Slot on cable management tray
Cutout
Faceplate connector
Cable connector
39140