Filter
Top Products
1-50
Cisco ONS 15454 Installation and Operations Guide
November 2001
Chapter 1 Hardware Installation
Card Installation
1.12.2 Gigabit Interface Converter
GBICs are hot-swappable input/output devices that plug into a Gigabit Ethernet (E1000-2 or E1000-2-G)
card to link the card with the fiber-optic network. Cisco provides two GBIC models: one for short reach
applications (part number 15454-GBIC-SX) and one for long-reach applications (15454-GBIC-LX).
The short reach, or “SX” model, connects to multimode fiber and the long reach, or “LX” model,
requires single-mode fiber. Because the GBICs are very similar in appearance, check the label on the
GBIC carefully before installing it.
For a description of GBICs and their capabilities, see Chapter 9, “Ethernet Operation.”
Procedure: Install Gigabit Interface Converters
Step 1 Remove the GBIC from its protective packaging.
Step 2 Check the part number to verify that the GBIC is the correct type for your network.
Step 3 Grip the sides of the GBIC with your thumb and forefinger and insert it into the slot on the front panel
of the Gigabit Ethernet card (shown in Figure 1-30).
GBICs are hot-swappable and can therefore be installed/removed while the card/shelf assembly is
powered and running.
Note GBICs are keyed to prevent incorrect installation.