Filter
Top Products
4-15
Cisco ONS 15454 Installation and Operations Guide
November 2001
Chapter 4 IP Networking
Viewing the ONS 15454 Routing Table
Dead Int (sec)—Sets the number of seconds that will pass while an OSPF router’s packets are not
visible before its neighbors declare the router down. Forty seconds is the default.
c. Click OK.
Step 9 After entering ONS 15454 OSPF area data, click Apply.
If you changed the Area ID, the TCC+ cards will reset, one at a time.
4.3 Viewing the ONS 15454 Routing Table
ONS 15454 routing information is displayed on the Maintenance > Routing Table tabs (Figure 4-11).
The routing table provides the following information:
• Destination—Displays the IP address of the destination network or host.
• Mask—Displays the subnet mask used to reach the destination host or network.
• Gateway—Displays the IP address of the gateway used to reach the destination network or host.
• Usage—Shows the number of times this route has been used.
• Interface—Shows the ONS 15454 interface used to access the destination. Values are:
–
cpm0—the ONS 15454 Ethernet interface, that is, the RJ-45 jack on the TCC+ and the LAN 1
pins on the backplane.
–
pdcc0—an SDCC interface, that is, an OC-N trunk card identified as the SDCC termination.
–
lo0—a loopback interface