Filter
Top Products
1-24
Cisco ONS 15454 Installation and Operations Guide
November 2001
Chapter 1 Hardware Installation
EIA Installation
Procedure: Install the AMP Champ EIA
Step 1 To remove the lower backplane cover, loosen the five screws that secure it to the ONS 15454 and pull it
away from the shelf assembly.
Step 2 Align the AMP Champ cover panel with the backplane and insert and tighten the nine perimeter screws
(P/N 48-0358) at 8-10 lbs.
Step 3 Align an AMP Champ card with the backplane connector and push until it fits snugly. Repeat until you
have installed all six AMP Champ cards.
Step 4 To secure each AMP Champ card to the cover panel, insert and tighten a screw (P/N 48-0003) at the top
of each card at 8-10 lbs.
Step 5 Place the AMP Champ fastening plate along the bottom of the cover panel, and hand tighten the two
thumbscrews.
Figure 1-19 shows an AMP Champ EIA installation.
Figure 1-19 Installing the AMP CHAMP EIA
44309