Filter
Top Products
66-14
Cisco ASA 5500 Series Configuration Guide using ASDM
Chapter 66 Configuring Active/Standby Failover
Monitoring Active/Standby Failover
Monitoring Active/Standby Failover
Note After a failover event you should either re-launch ASDM or switch to another device in the Devices pane
and then come back to the original ASA to continue monitoring the device. This action is necessary
because the monitoring connection does not become re-established when ASDM is disconnected from
and then reconnected to the device.
Choose Monitoring > Properties > Failover to monitor Active/Standby failover.
Feature History for Active/Standby Failover
Table 66-3 lists each feature change and the platform release in which it was implemented.
Table 66-3 Feature History for Optional Active/Standby Failover Settings
Feature Name Releases Feature Information
This feature was introduced.
7.0 This feature was introduced.
IPv6 support for failover added. 8.2(2) We modified the following screens:
Configuration > Device Management > High Availability >
Failover > Setup.
Configuration > Device Management > High Availability >
Failover > Interfaces.