Filter
Top Products
76-13
Cisco ASA 5500 Series Configuration Guide using ASDM
Chapter 76 Configuring Logging
Configuring Logging
Step 6 Click OK to close this dialog box.
Step 7 To continue, see the “Configuring the Remote SMTP Server” section on page 76-13.
Adding or Editing E-Mail Recipients
To add or edit e-mail recipients and severity levels, perform the following steps:
Step 1 Choose Configuration > Device Management > Logging > E-mail Setup.
Step 2 Click Add or Edit to display the Add/Edit E-Mail Recipient dialog box.
Step 3 Enter the destination e-mail address, and choose the syslog severity level from the drop-down list.
Severity levels are defined as follows:
• Emergency (level 0, system is unusable)
Note Using a severity level of zero is not recommended.
• Alert (level 1, immediate action is needed)
• Critical (level 2, critical conditions)
• Error (level 3, error conditions)
• Warning (level 4, warning conditions)
• Notification (level 5, normal but significant conditions)
• Informational (level 6, informational messages only)
• Debugging (level 7, debugging messages only)
Note The severity level used to filter messages for the destination e-mail address is the higher of the
severity level specified in the Add/Edit E-Mail Recipient dialog box and the global filter set for
all e-mail recipients in the Logging Filters pane.
Step 4 Click OK to close this dialog box.
The added or revised entry appears in the E-mail Recipients pane.
Step 5 Click Apply to save your changes to the running configuration.
Configuring the Remote SMTP Server
To configure the remote SMTP server to which e-mail alerts and notifications are sent in response to
specific events, perform the following steps:
Step 1 Choose Configuration > Device Setup > Logging > SMTP.
Step 2 Enter the IP address of the primary SMTP server.