Filter
Top Products
12-12
Cisco ASA 5500 Series Configuration Guide using ASDM
Chapter 12 Starting Interface Configuration (ASA 5510 and Higher)
Starting Interface Configuration (ASA 5510 and Higher)
Default Connector Type
The ASA 5550 (slot 1) and the 4GE SSM for the ASA 5510 and higher ASA include two connector
types: copper RJ-45 and fiber SFP. RJ-45 is the default. You can configure the ASA to use the fiber SFP
connectors.
Default MAC Addresses
By default, the physical interface uses the burned-in MAC address, and all subinterfaces of a physical
interface use the same burned-in MAC address.
Starting Interface Configuration (ASA 5510 and Higher)
This section includes the following topics:
• Task Flow for Starting Interface Configuration, page 12-12
• Converting In-Use Interfaces to a Redundant or EtherChannel Interface, page 12-13
• Enabling the Physical Interface and Configuring Ethernet Parameters, page 12-23
• Configuring a Redundant Interface, page 12-26
• Configuring an EtherChannel, page 12-29
• Configuring VLAN Subinterfaces and 802.1Q Trunking, page 12-35
• Enabling Jumbo Frame Support (Supported Models), page 12-38
Task Flow for Starting Interface Configuration
Note If you have an existing configuration, and want to convert interfaces that are in use to a redundant or
EtherChannel interface, perform your configuration offline using the CLI to minimize disruption. See
the “Converting In-Use Interfaces to a Redundant or EtherChannel Interface” section on page 12-13.
To start configuring interfaces, perform the following steps:
Step 1 (Multiple context mode) Complete all tasks in this section in the system execution space. If you are not
already in the System configuration mode, in the Configuration > Device List pane, double-click System
under the active device IP address.
Step 2 Enable the physical interface, and optionally change Ethernet parameters. See the “Enabling the Physical
Interface and Configuring Ethernet Parameters” section on page 12-23.
Physical interfaces are disabled by default.
Step 3 (Optional) Configure redundant interface pairs. See the “Configuring a Redundant Interface” section on
page 12-26.
A logical redundant interface pairs an active and a standby physical interface. When the active interface
fails, the standby interface becomes active and starts passing traffic.
Step 4 (Optional) Configure an EtherChannel. See the “Configuring an EtherChannel” section on page 12-29.
An EtherChannel groups multiple Ethernet interfaces into a single logical interface.