Cisco Systems MGX 8800 Switch User Manual


 
2-62
Cisco MGX 8800/8900 Series Hardware Installation Guide
Releases 2 - 5.2, Part Number OL-4545-01, Rev. H0, May 2006
Chapter 2 Illustrated Card List for MGX Switches and the MGX 8880 Media Gateway
Front Cards
The following module configurations are supported for the PXM45:
Standalone.
Card set redundancy (Y-cable).
Note For module configuration information, refer to Chapter 4, “Planning for Card Redundancy, Line
Redundancy, and Bulk Distribution”.
RPM-PR
Supported models: MGX 8850 (PXM1E/PXM45), MGX 8850/B (PXM1E/PXM45), MGX 8950, MGX 8830, MGX 8830/B, MGX 8880
The RPM-PR is a double-height service module that provides integrated IP on an ATM platform,
enabling services such as integrated Point-to-Point protocol (PPP).
The RPM-PR:
Provides an ATM interface to the switch and supports up to two port adapters, a four-port Ethernet
(10BASE-T), and a one-port Fast Ethernet (unshielded twisted pair [UTP], MMF)
Has a QED RM7000 processor subsystem that provides over 350 kilo packets per second (kpps) of
throughput for IP packet forwarding
Provides integrated IP in an ATM platform
Has an attached daughter card that contains the processing intelligence and contains the firmware
that determines the interface type (OC-3c, OC-12c, T3, E3, and so forth)
When the RPM-PR is combined with one or two back cards, a card set is created. Table 2-26 provides
information about each RPM-PR card, interface, and corresponding back card.
Table 2-26 RPM-PR Cards, Interfaces, and Supported Back Cards
RPM-PR
Switch
Interface
Supported
Back Card Ethernet Interfaces
Number of
Ethernet
Interfaces
RPM-PR-256
(256 MB DRAM)
NNI/UNI MMF-FE Fast Ethernet, 100BASE-FX; choice of SC or MII
connector. MII connector requires external transceiver.
1
RJ45-4E/B Ethernet 10BASE-T 4
RJ45-FE Fast Ethernet, 100BASE-FX; choice of RJ-45 or MII
connector. MII connector requires external transceiver.
1
MGX-RPM-1
FE-CP
Fast Ethernet, 100 BASE-TX, with coprocessor and RJ-45
connector.
1
MGX-RJ45-5-
ETH
Ethernet/Fast Ethernet/Gigabit Ethernet, 10 BASE-T,
100 BASE-TX, and 1000 BASE-T with RJ45 connector.
5