Filter
Top Products
5-131
Cisco MGX 8800/8900 Series Hardware Installation Guide
Releases 2 - 5.2, Part Number OL-4545-01, Rev. H0, May 2006
Chapter 5 Installing the Cisco MGX Switch or Gateway
Installing the MGX 8830 or MGX 8830/B Switch
Connect the MP Connection
Note This step is optional.
A dial-up connection extends switch management to all workstations that have access to the public
switched telephone network (PSTN).
PXM-UI-S3
Connect the maintenance port (MP) on the PXM-UI-S3 card to a modem. Connect the terminal to a
power source and set it up using the values that are shown in Table 5-8. This modem is connected through
the PSTN and is accessible from a workstation, as shown in Figure 5-84.
PXM-UI-S3/B
A PXM-UI-S3/B card does not have a maintenance port. For the PXM-UI-S3/B card, a modem can be
connected to the console port instead of the MP.
Figure 5-84 Modem Connection to the Maintenance Port
For further information about server management and configuration setup, refer to the appropriate
software configuration guide for your switch and your release.
44373
PXM
UI-S3
C
P
M
P
A
L
1
N
L
2
N
A
L
A
A
R
M
E
X
T
C
L
K
1
E
X
T
C
L
K
2
Workstation
Modem
Modem
PXM-UI-S3
back card