Filter
Top Products
3-68
Cisco MGX 8800/8900 Series Hardware Installation Guide
Releases 2 - 5.2, Part Number OL-4545-01, Rev. H0, May 2006
Chapter 3 Preparing for Installation
Site Requirements for the MGX 8880 Media Gateway
Fan tray power cable
DC PEM power cable—For DC-powered systems
Optional AC power supply tray power cable—For AC-powered systems
AC power cord for AC power supply tray, optional for AC power:
• Argentina: Cisco Part Number CAB-ACR
• Australia: Cisco Part Number PWRCD-ANZ
• Continental Europe: Cisco Part Number PWRCD-EU
• Great Britain: Cisco Part Number PWRCD-GBI
• Ireland: Cisco Part Number PWRCD-GBI
• Italy: Cisco Part Number PWRCD-IT
• Japan: Cisco Part Number PWRCD-NA
• New Zealand: Cisco Part Number PWRCD-ANZ
• North America: Cisco Part Number PWRCD-NA (NEMA L6-20 twistlock plug)
Wire for DC power connection—6 AWG (10 square mm) or larger three-wire solid or
stranded copper wire with insulation rating for 140°F (60°C)
Stability plate kit, optional—Cisco Part Number STRATM-STAB
ESD protection equipment—Required whenever you handle Cisco equipment, which
includes the switch, cards, and modules
Mounting screws—To mount the Cisco MGX 8880 Media Gateway, exhaust plenum/fan
tray, air intake plenum, and optional AC power supply tray in the rack
Tools
Small- and medium-sized flat-blade screwdrivers
Small- and medium-sized Phillips screwdrivers
3-in-1 tool (part 700-07569-01) with the following heads:
• A flat head for unlatching front card ejectors and loosening and tightening the back card
captive screws
• A hex head for unlatching the chassis door
• A Phillips head for loosening and tightening the back card captive screws
Power screwdriver, optional
Wire stripper
Wire-wrapping tool, optional
Fuse replacement tool (218090-00).
Warning
This tool should only be used by trained personnel.
Table 3-29 MGX 8880 Media Gateway Required Tools and Equipment (continued)
Check Tools and Equipment