Filter
Top Products
5-119
Cisco MGX 8800/8900 Series Hardware Installation Guide
Releases 2 - 5.2, Part Number OL-4545-01, Rev. H0, May 2006
Chapter 5 Installing the Cisco MGX Switch or Gateway
Installing the MGX 8830 or MGX 8830/B Switch
Tip If the screw holes on the card cage are not aligned with the holes on the frame, place a flat-blade
screwdriver between the card cage and fan tray to raise the card cage. Insert the screws and tighten them,
and then remove the screwdriver from between the fan tray and card cage.
Tip If a component requires more than two screws for installation in the rack or cabinet, install the two
bottom screws first.
Warning
Never attempt to lift the chassis with the handles on the power supplies, fan trays, or the switching
modules. These handles are not designed to support the weight of the chassis. Using them to lift or
support the chassis can result in severe damage to the equipment and serious bodily injury.
Statement 50
Install the Switch in a 19-Inch or 23-Inch Rack
Complete the following steps to install the MGX 8830 switch in a 19-inch or 23-inch rack:
Step 1 Attach one mid-mounting bracket to each side of the Cisco MGX 8830 switch before installing the unit
in a rack.
Note You need a mounting kit to accommodate a 23-inch rack (Cisco Part Number
MGX-8830-MNT23).