Filter
Top Products
Figures
xxiv
Cisco MGX 8800/8900 Series Hardware Installation Guide
Releases 2 - 5.2, Part Number OL-4545-01, Rev. H0, May 2006
Figure 5-65 MGX 8830 Stability Plate Dimensions 5-102
Figure 5-66 Installing a Cisco Cabinet over the Stability Plate 5-103
Figure 5-67 Frame Bonding Connection in Cisco-Supplied Rack 5-105
Figure 5-68 Component Locations in a MGX 8830 System 5-106
Figure 5-69 Mounting Rail Distances 5-107
Figure 5-70 Front Card Extractor Lever 5-111
Figure 5-71 Connecting the Back Card to the MGX8830-APS-CON Connector 5-114
Figure 5-72 Two Back Cards in the MGX8830-APS-CON Connector 5-115
Figure 5-73 Front View with the Mid-Mounting Brackets Attached—19-Inch Rack 5-120
Figure 5-74 Front View with the Mid-Mounting Brackets Attached—23-Inch Rack 5-120
Figure 5-75 Rear View with the Rear-Mounting Brackets Attached 5-121
Figure 5-76 Cable Management Assembly on the Rear of the Switch 5-122
Figure 5-77 Two AC Power Supplies Installed in the MGX 8830 Switch 5-123
Figure 5-78 Workstation Connection to the Console Port 5-125
Figure 5-79 Terminal Server Connection to the Console Port 5-126
Figure 5-80 Rear View of the MGX 8830 with Two DC PEMs Installed 5-128
Figure 5-81 DC PEM Faceplate 5-128
Figure 5-82 Polarities at the MGX 8830 PEM Pluggable Terminal Block 5-129
Figure 5-83 Pluggable Terminal Block on MGX 8830 DC PEM 5-129
Figure 5-84 Modem Connection to the Maintenance Port 5-131
Figure 5-85 Ethernet Connection to the LAN 1 Port 5-132
Figure 5-86 Place a Ferrite Bead on the Cables that Lead to RJ Connectors (1, 3, 4, 5, and 6) 5-134
Figure 5-87 How to Open the Ferrite Bead 5-134
Figure 5-88 Snap the Ferrite Bead Closed on the Cable Leading to the PXM-UI-S3/B Back Card 5-135
Figure 5-89 Place Two Ferrite Beads on the Cables that Lead to Connectors 3 and 4 5-136
Figure 6-1 DC PEM Faceplate 6-3
Figure 6-2 Terminal Block on the DC PEM 6-4
Figure 6-3 How to Open a Card’s Latch or Extractor Lever 6-6
Figure 6-4 Protective Cover Removal 6-7
Figure 6-5 Transceiver Removal from the Back Card 6-12
Figure 6-6 Transceiver Installed in the Back Card 6-13
Figure 6-7 Center Guide Module Position in an MGX 8850 or MGX 8950 Chassis 6-15
Figure 6-8 Removal of the Center Guide Module 6-16
Figure 6-9 Guide Module Support Bracket 6-17
Figure 6-10 Connecting the Back Card to the APS Connector (MGX 8830 Example) 6-18