Filter
Top Products
5-91
Cisco MGX 8800/8900 Series Hardware Installation Guide
Releases 2 - 5.2, Part Number OL-4545-01, Rev. H0, May 2006
Chapter 5 Installing the Cisco MGX Switch or Gateway
Installing the MGX 8950 Switch
Warning
Do not touch the power supply when the power cord is connected. For systems with a power switch,
line voltages are present within the power supply even when the power switch is off and if the power
cord is connected. For systems without a power switch, line voltages are present within the power
supply when the power cord is connected.
Statement 4
Connect AC Power to the Switch
To connect AC power to the MGX 8950 switch, use AC power cords with the following types of AC wall
plugs:
• 30A NEMA L620, 3-prong plug (North America), shown in Figure 5-57.
Figure 5-57 AC Power Cable (North America)
• 30A IEC 309 plug (Europe, Australia, New Zealand), shown in Figure 5-58.
Figure 5-58 AC Power Cable IEC 309 Plug (International)
Complete the following steps to connect a North American AC power cord to the switch:
Step 1 Insert the female connector into the AC receptacle on the AC power supply tray.
Step 2 Twist the plug to the right to secure it.
Step 3 Insert the other end of the power cable into the wall outlet.
Step 4 Repeat Step 1 through Step 3 to connect the other AC cable to the remaining AC power supply tray.
Complete the following steps to connect an international AC power cable to the switch:
Step 1 Insert the female connector into the AC power supply tray receptacle, as shown in Figure 5-59.
44147x
To power supply To AC outlet
75422
To AC outlet