Filter
Top Products
Appendix B Accessories|
B-18 Revision Nov. 2008, VLE1, SW V1.03
Display Message Descriptions
-DC SBU OEVALT G EEE
EREEEE 1E706. V Edc
Press MODE key
Displays the voltage of DC BUS
TOU TPU UECERR N ETE
ESEEEE 0EE 0.0 A smp
Press MODE key
Displays the output current present at terminals U/T1, V/T2, and W/T3
TOU TPU OEVALT G EEE
ESEEEE EEE 00. V tol
Press MODE key
Displays the output voltage of motor
OU: put Eut rCu r ten
ESEEEE 0EE A.0 m Eps
Press MODE key
User defined unit (Where U= Pr.00-04)
RPA EAM PCO EYEE EEE
ESE EER EAD E1EE EEE
Copy the first set of parameter groups from the drive to the keypad. It can
save two sets of parameter groups to keypad. (one set is from group 0 to
group 13)
RPA EAM PCO EYE
E
EEE
ESE AES EVE v1E 10.0
Save the first set of parameter groups from the keypad to other drive.
The firmware version is 1.00.
SSY MTE AEPMRA E RTE
-S0EEE EEE 0EE 0 E- E
Displays the group number
tRa Eed rCu nre t EEE
EEE EEE 2EE 17. 0 pAm
Displays the actual stored value of the selected parameter
tEx ner Eal uFa l Et E
EFEE
06
C
eod :
a
F
u
l
t
External Fault
EEE E-- dEn -. E - EEE
EEE EEE EEE EEE E EEE
Display “End” for approximately 1 second if input has been accepted by
pressing PROG/DATA key. After a parameter value has been set, the new
value is automatically stored in memory.
EEE E-- rEr -. E - EEE
EEE EEE EEE EEE E EEE
Display “Err”, if the input is invalid.