Filter
Top Products
3–Interactive Commands
Target Persistent Bindings Menu (Command Line Option -p)
3-54 SN0054614-00 K
New iiDMA setting has been saved to seleted target(s) on HBA
instance 0.
iiDMA Settings: Disk
5: iiDMA Settings 1 - n: HBA Port n n: Disk n
When you select a specific disk on the adapter port, the following options are
available on the iiDMA Menu (Advanced):
1 Gps
2 Gps
4 Gps
iiDMA: All HBAs
5: iiDMA Settings n: All HBAs
When you select All HBAs to configure, the options for Basic Configuration and
Advance Configuration appear on the menu. See “Configuring the iiDMA
Settings” on page 3-48.
Target Persistent Bindings Menu
(Command Line Option -p)
6: Target Persistent Bindings
When you select this option, SANsurfer FC/CNA HBA CLI shows the Target
Persistent Binding menu listing standard adapter port instances (see “HBA Port
Instance” on page 3-49), where you can select an individual adapter port or All
HBAs.
The following sections describe how to view, set, and delete the adapter’s target
persistent binding in interactive and non-interactive modes.
Whether you select a specific adapter port instance or All HBAs, the Target
Persistent Bindings Menu appears.
NOTE:
In a Solaris OS, QLA/QLE24xx and QEM2462 adapters with a QLA
driver allow up to 2048 targets with target IDs in the range of 0–2047.
In a Solaris OS, QLA/QLE23xx adapters with a QLA driver allow up to
256 targets with target IDs in the range of 0–2047.
Under Solaris, this feature is disabled if you are using the driver from the
OS installation CDs (QLC driver). Under Linux, this feature is disabled if
you are using the IOCTL or sysfs (inbox) driver.