Filter
Top Products
4–Non-Interactive Commands
Command Summary
SN0054614-00 K 4-35
To disable (deselect) a LUN on a specific target on a specific adapter, type:
# scli -m (<hba instance> | <hba wwpn>) {<target wwnn> <target
wwpn> <lun id> (0 | disable | deselect)}
To enable (select) all LUNs for a specific target on a specific adapter, type:
# scli -m (<hba instance> | <hba wwpn>) select | enable
<target wwnn> <target wwpn>
To disable (deselect) all LUNs for a specific target on a specific adapter, type:
# scli -m (<hba instance> | <hba wwpn>) deselect | disable
<target wwnn> <target wwpn>
To enable (select) all LUNs of all targets on a specific adapter:
# scli -m (<hba instance> | <hba wwpn>) select all
To disable (deselect) all LUNs of all targets on a specific adapter:
# scli -m (<hba instance> | <hba wwpn>) deselect all
-n
(Set Selected HBA Parameter)
To set a specific parameter on a specific adapter, type:
# scli -n (<hba instance> | <hba wwpn>) { (<param name> |
<param alias>) <param value>}
To restore the default BIOS (4G adapters only), type:
# scli -n (<hba instance> | <hba wwpn>) default
Where:
NOTE:
You can repeat the sequence <target wwnn> <target wwpn> <lun
id> 1 to select multiple LUNs in the same command.
NOTE:
To select multiple LUNs in the same command, repeat the following
sequence:
<target wwnn> <target wwpn> <lun id> 0
hba instance = Adapter number (use -g command to find)
hba wwpn = World wide port name of the adapter
param name = Name of the parameters