Filter
Top Products
4–Non-Interactive Commands
Command Summary
4-48 SN0054614-00 K
# scli -vp (<hba instance> : <hba wwpn>) list <vport wwpn>
To create a virtual port with an automatic WWPN, type:
# scli -vp (<hba instance> : <hba wwpn>) create auto
To create a virtual port with a specific WWPN, type:
# scli -vp (<hba instance> : <hba wwpn>) create <vport hex>
When prompted, enter two hexadecimal digits. The system checks these digits to
be sure they are unique and, if they are, puts them into byte 1 of the WWPN.
To delete all virtual ports on a physical adapter port, type:
# scli -vp (<hba instance> : <hba wwpn>) delete all
To delete a specific virtual port on a physical adapter port, type:
# scli -vp (<hba instance> : <hba wwpn>) delete <vport wwpn>
-x
(Output in XML Format 1)
You can use this option with all non-interactive mode options that have a
corresponding interactive mode option (see Table 4-1). This option must be the
first or last command in the command line.
When you use this option, the system shows all result and status messages in
XML format 1, a legacy format. These formats are described in Appendix A. This
option is usually combined with the -o option (see “-o (Output to a File)” on
page 4-37) to create a text file with XML output so that it can be parsed by an
XML-compliant utility. For example to show adapter general information and
output it to an XML file named output.xml:
# scli -i all -x -o output.xml
-x2
(Output in XML Format 2)
NOTE:
This option is valid only in non-interactive mode.
NOTE:
This option is valid only in non-interactive mode.