Q-Logic FC Network Card User Manual


 
3–Interactive Commands
Driver Settings Menu (Command Line Option -fg)
SN0054614-00 K 3-63
The current settings for the Present persistently bound target(s)... and Bind
by... are indicated by the word Current in parentheses after the selection. To
change these settings, select the menu number corresponding to the other option.
To save your changes, select Commit Changes.
Table 3-4 shows the driver settings.
NOTE:
Options on the Driver Settings menu differ according to the driver type:
failover, non-failover, Windows, Solaris, or Macintosh:
Present persistently bound target(s) plus any new target(s) with
driver default (option available for all drivers)
Present persistently bound target(s) Only (option available for all
drivers)
Present targets with driver default (option available for failover driver
only)
Bind by World Wide Port Name (option available for all drivers except
Macintosh driver)
Bind by Port ID (option available for all drivers except Macintosh driver)
Commit Changes
NOTE:
If you select a QLA22xx adapter, all QLA22xx adapters on the host will use
the same settings. If you select a 23xx adapter, all 2Gb and 4Gb adapters on
the host will also use the same settings. If you select any other adapter, all
other 2Gb, 4Gb, and 8Gb adapters on the host will also use the same
settings.
Table 3-4. Driver Settings
Parameter Name
<param name>
Alias
<param
alias>
Value
<param
value>
Description
PersistentOnly PO 0, 1 Present persistently bound
target(s) only.
Persistent-
PlusNew
PN 0, 1 Present persistently bound
target(s) plus any new tar-
get(s) with driver default.