Filter
Top Products
4–Non-Interactive Commands
Command Summary
SN0054614-00 K 4-27
-kl (<hba instance> | <hba wwpn>) [{(<param name> | <param
alias>) <param value>}]
-kl
(Run HBA Diagnostics Loopback Test)
The <param name>, <param alias>, and <param value> options are described in
Table 4-11.
The system shows the following information after a loopback test completes:
Test status
CRC error
Disparity error
Frame length error
-kr
(Run Read/Write Buffer Test)
Use the -kr command to do read/write buffer test. (To run the loopback test, use
the -kl command—see “-kl (Loopback Test)” on page 4-20.)
To do a read/write test using the default parameters, type:
# scli -kr (<hba instance> | <hba wwpn>)
To do a read/write test with customized parameters, type:
# scli -kr (<hba instance> | <hba wwpn>) [(-EX | -EXCLUDE)
<target wwpn>] (<param name> | <param alias>) <param value>
NOTE:
Under Solaris, this feature is disabled if you are using the driver from the OS
installation CDs (QLC driver).