Q-Logic FC Network Card User Manual


 
3–Interactive Commands
Target/LUN List Menu (Command Line Options -t and -l)
3-36 SN0054614-00 K
The priority pause mask is a bitmap of CoS values for which pause is being
enabled. SANsurfer FC/CNA HBA CLI allows you to select or clear boxes from 0
to 7, representing the different CoS values for which pause is being enabled (or
disabled). Because FCoE uses CoS 3 and because FC is lossless, you must
enable pause for CoS 3.
If you need to change the FCoE CoS value, you should also enable pause for the
new CoS value.
These values need not be modified when talking to a switch that supports DCBX
(for example, the Cisco Nexus 5020 switch). The values are valid only when
talking to a switch that does not support DCBX.
HBA Parameters (All HBAs)
3: HBA Parameters n: All HBAs
When you select this option, the parameters listed in “HBA Parameters (Per
Adapter Port)” on page 3-25 appear for every adapter.
Target/LUN List Menu
(Command Line Options -t and -l)
4: Target/LUN List
This option shows the main Target List Menu, which includes a list of all adapters
and port instances detected on the host. You have the option to select:
Each adapter port individually
All adapters
Here is an example of the Target List Menu:
HBA Model QLA2462
1: Port 1: WWPN: 21-00-00-E0-8B-1F-9D-F0 Online
2: Port 2: WWPN: 21-01-00-E0-8B-3F-9D-F0 Online
HBA Model QLE2562
3: Port 1: WWPN: 21-00-00-1B-32-1B-4E-4C Online
4: Port 2: WWPN: 21-01-00-1B-32-3B-4E-4C Online
5: All HBAs
6: Return to Previous Menu
Table 3-2 lists the variables and their descriptions for target/LUN information.