Q-Logic FC Network Card User Manual


 
4–Non-Interactive Commands
Command Summary
4-42 SN0054614-00 K
-q
(View or Set Target Link Speed)
Type the following command to view the link speed of all targets attached to one
adapter or all adapters:
# scli -q (
<hba instance>
|
<hba wwpn>
| <all>)
[-targets | -t ]
Where:
To view the link speed of a specific target attached to an adapter, enter the
following command:
# scli -q (<hba instance> | <hba wwpn> | <target wwpn>
Where:
To set the link speed of all targets attached to one adapter or all adapters to the
designated speed, enter the following command:
# scli -q (<hba instance> | <hba wwpn> | <all>) <-targets | -t
><speed>
Where:
NOTE:
The -q option is supported only on 4GB adapters.
hba instance = Adapter number (use -g command to find)
hba wwpn = World wide port name of the adapter
all = Reports link speed for all targets on all adapters in the system
-targets = All targets
-t = All targets
hba instance = Adapter number (use -g command to find)
hba wwpn = World wide port name of the adapter
target wwpn = World wide port name of the target
hba instance = Adapter number (use -g command to find)
hba wwpn = World wide port name of the adapter
all = Reports link speed for all targets on all adapters in the system
-targets = All targets
-t = All targets
speed = Link speed (