Q-Logic FC Network Card User Manual


 
3–Interactive Commands
HBA Parameters Menu
3-26 SN0054614-00 K
Display HBA Parameters
(Command Line Option -c#)
3: HBA Parameters n: Port Instance 1: Display HBA Parameters
When you select this option, the following parameters appear:
Connection Options
Data Rate (4Gb and above adapters)
Frame Size
Hard Loop ID
Loop Reset Delay (seconds)
Enable Host Adapter BIOS
Enable Hard Loop ID
Enable FC Tape Support
Operation Mode
Interrupt Delay Timer (100 ms)
Execution Throttle
Login Retry Count
Enable LIP Reset
Port Down Retry Count
Enable LIP Full Login
Link Down Timeout (seconds)
Enable Target Reset
LUNs Per Target
Enable Receive Out Of Order Frame
Configure HBA Parameters
(Command Line Option -n)
3: HBA Parameters n: Port Number 2: Configure HBA Parameters
From the Configure HBA Parameters menu, you can configure the following
adapter parameters:
Connection Options
Data Rate
Frame Size
Hard Loop ID
Loop Reset Delay (seconds)
Enable Adapter Port BIOS
Enable Adapter Hard Loop ID
Enable Fibre Channel Tape Support
Operation Mode
Interrupt Delay Timer
Execution Throttle
Login Retry Count
Enable LIP Reset
Port Down Retry Count