Q-Logic FC Network Card User Manual


 
D–Help Commands
D-2 SN0054614-00 K
<target wwpn> World wide port name of a target device.
(xx-xx-xx-xx-xx-xx-xx-xx or xxxxxxxxxxxxxx).
<vport hex> World wide port name of the virtual port with the two hexadeci-
mal digits in byte three supplied by the user.
<vport wwpn> World wide port name of a virtual port.
Table D-2. Help Commands
Command
Line Action
Arguments Function
[ int ] Starts interactive mode.
–a ( <hba instance> | <hba wwpn> ) Flashes the adapter port LED to locate it in
the host. This feature is not supported on
QLA22xx series adapters.
–a ( <hba instance> | <hba wwpn> )
( view | ?)
Shows the current LED state on an adapter
port.
–b ( <all> | <hba instance> | <hba
wwpn> ) [ ( <–rg> <fw | boot|
all> ) ] <file name>
Updates the adapter boot code from a file,
where:
<–rg> Specifies Option ROM region
update mode.
<all> Updates the flash from a full
image file (1MB image file).
<file name> Flash image file name.
Note: Region update is not available on
2Gb adapters. Flash update is not sup-
ported on 2Gb adapters in Macintosh. If
selected multiple adapters, only adapters
that are compatible with the provided flash
image will be updated.
–b ( <hba instance> | <hba wwpn> )
save <file name>
Saves the adapter boot code to a file.
–c ( <hba instance> | <hba wwpn> ) Views the adapter parameters settings of
an adapter port.
–c [ <all> ] Views the adapter parameters settings of
all adapters.
Table D-1. Variables Used in Arguments (Continued)
Variable Description