Filter
Top Products
Error & Status Messages on the Operation Panel
103
10
Reset Tray(s)
Correctly
The tray on the paper feed-
ing path is not set correctly
when the printer receives
the print job.
Set the tray correctly. The printer
will re-start printing automatical-
ly.
Tray XX
Add Paper
Paper runs out in tray XX. Load paper.
⇒ P.79
“Type 1 Printer: Loading
Paper and Other Media”
⇒ P.88
“Type 2 Printer: Loading
Paper and Other Media”
Error
SC_320
The toner cartridge may not
be installed when the printer
tries to start printing.
Open the front cover and check if
the cartridge is installed. If not,
install the cartridge. ⇒ P.114
“Re-
placing the Toner Cartridge”
If the cartridge is installed, close
the front cover and turn the
printer's power switch off and
on. If the message appears again,
contact your sales or service rep-
resentative.
Error
SC_2700
An error has occurred in the
optional network interface
board.
Remove the network interface
board from the printer and turn
the printer's main switch off and
on. Then, try to perform your
print job.
Note
❒
If you remove the network in-
terface board, you cannot per-
form your print job over the
network. You can send your
print job to the printer only
via a parallel cable connec-
tion.
Error
SC_3200
Error
SC_3201
Error
SC_3100
An error has occurred in the
optional memory unit
(SIMM).
Remove the memory unit from
the printer and turn the printer's
main switch off and on. Then, try
to perform your print job.
Note
❒
If you remove the memory
unit, you might not be able to
perform a print job containing
the large complex data.
Messages Description Comments