Filter
Top Products
Copyright© 1999 G032-8617 Printed in Japan
UE
INSTALLING THE PAPER TRAY
Caution
•
The paper tray does not have a stopper. When
pulling it out, be careful not to pull it strongly. If
you do, the tray might fall and cause personal
injury.
The default settings of the paper size as follows:
•
Metric version: A4
K
(short-edge feed)
•
Inch version: 8
1
/
2
" x 11"
K
(short-edge feed)
If you want to use other sizes, set paper in the
optional tray.
For more information about the paper sizes that
can be set in the paper tray, see “Paper and Other
Media Supported by Your Printer” in the “Operating
Instructions”.
Pull the paper tray out of the printer. Place it on a
flat surface.
TS4K140E
Load paper into the paper tray with the print side up.
TS4J150E
Important
❒ Make sure that the top of the stack is not higher
than the limit mark inside the tray.
❒ Make sure the paper fits under the rear guides.
Insert the paper tray into the printer until it stops.
TS4K160E
PRINTING THE TEST PAGE
You can check if the printer works properly by
printing a test page (configuration page).
However, you cannot check the connection
between the printer and your computer by printing
the test page.
Check that the power switch is turned on.
Press the Menu key.
The following message appears on the panel display.
Main Menu: ▲
Job Control ▼
Press the
▲
▼
keys until the following message
appears on the panel display.
Main Menu: ▲
List Print ▼
Press the Enter key.
The following message appears on the panel display.
List Print: ▲
1.Config. page ▼
Press the Enter key.
The following message appears on the panel display.
Config. page:
Press Enter key
Press the Enter key.
In a short time, the test printing will start.
Important
❒ If you cannot complete the test printing correctly,
check if an error message appears on the panel
display. For more information about error
messages, see “Troubleshooting” in the “Operating
Instructions”.
❒ After installing the new toner cartridge, the first
few pages might be printed with light density. If
density does not become darker, see
“Troubleshooting” in the “Operating Instructions”.
SETTING UP FOR PRINTING
Printing requires installation of a printer driver for
your operating system.
See “Printer Drivers for Your Printer” in the
“Operating Instructions”.
CONNECTING THE PRINTER TO A
COMPUTER
Connect the printer to your computer using a
parallel port.
Important
❒ The parallel interface cable is not provided with
the printer. It is your responsibility to provide the
interface cable appropriate for the computer that
you are using.
❒ The printer’s parallel connection is a standard bi-
directional interface. It requires a standard 36-pin
parallel cable compliant with IEEE1284 and a
parallel port available on your computer.
❒ To avoid electrical interference, use the shielded
cable.
Note
❒ Do not use a parallel cable more than 2.5 meters
(8.2 feet) long.
Turn off the printer’s power switch.
Turn your computer off.
Attach the interface cable to the interface
connector of the printer. Secure the cable with
the metal fittings as shown in the illustration.
TS4K170E
Attach the other end of the interface cable to the
interface connector of the computer. Secure the
cable.