Filter
Top Products
Chapter 7 - 20
7.5.5 Reset Unit
To reset the Network Interface Board, at the Main menu type 4 and press the ENTER key.
Then you will be asked whether to reset the card or not with a warning message.
7.5.6 Restore Factory
When it is necessary to restore factory defaults on your print server, choose 5 on the Main
Menu and press the ENTER key. All NVRAM stored parameters will be returned to their
factory default values. The factory default values will not take effect until the Telnet program
is exited or the unit is power-cycled.
7.5.7 Change Password
When you want to establish a new password, enter 6 from the Main menu. Type up to eight
characters after the New Password query and press the ENTER key. Retype the same
characters at the Retype New Password query and press the ENTER key. Use the Save
Changes and Exit option. Once you have established your password using Change
Password, the password sysadm will be rejected.
Note: There is a single maintenance access password to the Network Interface Board.
This password is used for both Telnet and HTML maintenance programs. This password
may be changed from Telnet or from HTML (accessed either via MAP or Web Browser
utility.
7.5.8 Exit Telnet
Use the following procedures to exit Telnet:
1.
To end your Telnet session, type E at the main menu. If you have made any changes,
the following menu will appear:
The Configuration Utility
Unit Serial no. 991398 v2.18
Exit
1. Save Changes and Exit
2. Save Changes and Reset
3. Exit Without Saving Changes
Please Enter Selection (? for Help) :
2. Choose your option and press the ENTER key. For example, type 2 and press the
ENTER key. The program will save your changes and reset the print server so that the
changes will take effect.