Filter
Top Products
Type 2 Printer: Installing Options
23
2
sistance before popping into
place.
Note
❒
Use a coin to reattach the screws
E
Loop the network interface cable
and attach the ferrite core as
shown in the illustration.
Note
❒
The network interface cable
loop should be about 15 cm (6")
(
A
) from the end of the cable
(on the end closest the printer).
The ferrite core at the end of the
cable should be a ring type fer-
rite core.
F
Attach the network interface ca-
ble to the jack on the board as
shown in the illustration.
G
Connect the other end of the net-
work interface cable to the net-
work.
H
Plug the printer's power cord
back into the wall outlet and turn
on the printer's power switch.
The configuration page of the net-
work interface board will be print-
ed automatically. Check the
configuration of the network inter-
face board with it.
Important
❒
After installing the network in-
terface board properly, set up
the printer's network environ-
ment using the operation panel.
See P.25
“Configuring the Printer
for the Network with the Operation
Panel”
.
Type 2 Printer: Installing the
Memory Unit (SIMM)
Note
❒
Please refer to the inside of the
front cover of this manual to con-
firm which printer (Type 1 Printer
or Type 2 Printer) you have.
TS4P090E
TS3P110E
1
TS4C041E