Filter
Top Products
Type 1 Printer: Installing Options
17
2
❒
Use the shielded twisted-pair
(STP) network interface cable.
❒
The network interface board can
be attached to either the left or the
right side of the back of your print-
er. This procedure is for attaching
to the left side.
❒
You cannot install two network in-
terface boards at a time.
A
Check the contents of the box for
the following items.
• Network interface board
• CD-ROM
• Ferrite Core
• Installation Guide
• Quick Configuration Guide
• Additional Documentation
B
Be sure to check the following
points:
• The printer's power switch is
turned off.
• The power cord is unplugged
from the wall outlet.
C
Remove the back plate.
Note
❒
A coin can be used to remove
the screws.
D
Align the screw holes of the net-
work interface board over the
screw holes where the back plate
used to be. Make sure that the
board is aligned so that the jack is
facing out and is on the bottom.
Press the board firmly against the
printer. The interface connectors
on the printer and the board
should align and offer a slight re-
sistance before popping into
place.
Note
❒
Use a coin to reattach the
screws.
E
Loop the network interface cable
and attach the ferrite core as
shown in the illustration.
Note
❒
The network interface cable
loop should be about 15 cm (6")
(
A
) from the end of the cable
(on the end closest to the print-
er). The ferrite core at the end of
the cable should be a ring type
ferrite core.
TS3P080E
TS3P090E
TS3P110E
1