Filter
Top Products
Installing Options
18
2
F
Attach the network interface ca-
ble to the jack on the board as
shown in the illustration.
G
Connect the other end of the net-
work interface cable to the net-
work.
H
Plug the printer's power cord
back into the wall outlet and turn
on the printer's power switch.
The configuration page of the net-
work interface board will be print-
ed automatically. Check the
configuration of the network inter-
face board with it.
Important
❒
After installing the network in-
terface board properly, set up
the printer's network environ-
ment using the operation panel.
See P.25
“Configuring the Printer
for the Network with the Operation
Panel”
.
Type 1 Printer: Installing the
Memory Unit (SIMM)
Note
❒
Please refer to the inside of the
front cover of this manual to con-
firm which printer (Type 1 Printer
or Type 2 Printer) you have.
Important
❒
The memory unit can be damaged
by small amount of static electrici-
ty. Before touching it, touch some-
thing metal to remove static
electricity from you.
❒
To make the printer recognize the
installed option, you should set up
the option with the printer driver.
❒
This printer has one slot for a
SIMM, and you can install one
SIMM at a time.
A
Be sure to check the following
points:
• The printer's power switch is
turned off.
• The power cord is unplugged
from the wall outlet.
B
Remove the back plate.
Note
❒
A coin can be used to remove
the screws.
C
Make sure that the notch of the
memory unit should be upward
as shown in the illustration. Tilt
the memory unit to the left so that
it is in 45 degrees from perpendic-
ular to the slot, and slide it into
the slot (
A
). Tilt the memory unit
so that it is perpendicular to the
TS3C041E
TS3P030E