Filter
Top Products
Phaser 8400/8500/8550/8560 Color Printer Service Manual 3-57
Error Messages and Codes
P4G Process motor stalled while the printer performed an auto Drum maintenance
cycle.
P4H Process motor stalled while the printer performed Printhead maintenance.
P4J Process motor stalled while the printer performed Printhead purge.
P4K Process motor stalled while the printer performed an oil transfix roller cycle.
P4L Process motor stalled while the printer was in standby mode.
P4S Process motor stalled while the printer staged for transfix.
P4T Process motor stalled while the printer transfixed the print.
P4V Process motor stalled while the printer performed a print Drum maintenance
cycle.
P4W Process motor stalled while the printer imaged the Drum.
P4X Process motor stalled while the print exited the printer.
1. Ensure the media is supported.
2. Verify that the Process Drive Gearbox is correctly aligned and homed.
3. Run the Process Motor test.
4. Replace the process motor if necessary.
5. Run the Transfix Fast and Slow tests.
6. Replace the transfix camshaft and load arms if necessary.
7. Run the Tilt Drive test, replace if necessary.
8. Replace the Process Drive.
T2A
The Exit Cover open flag unexpectedly tripped while the printer was
performing an abnormal shutdown.
T2B The Exit Cover open flag unexpectedly tripped while the printer was
performing a normal shutdown.
T2C The Exit Cover open flag unexpectedly tripped while the printer was
performing a mechanical recovery.
T2D The Exit Cover open flag unexpectedly tripped while the printer was warming
up.
T2E The Exit Cover open flag unexpectedly tripped while the printer was ready.
T2F The Exit Cover open flag unexpectedly tripped while the printer was in a fault
state.
T2G The Exit Cover open flag unexpectedly tripped while the printer was
performing an automatic Drum maintenance cycle.
T2H The Exit Cover open flag unexpectedly tripped while the printer was
performing a Printhead maintenance cycle.
T2J The Exit Cover open flag unexpectedly tripped while the printer was
performing a Printhead purge cycle.
T2K The Exit Cover open flag unexpectedly tripped while the printer was
performing a transfix oiling cycle.
T2L The Exit Cover open flag unexpectedly tripped while the printer was in Standby
mode.
Jam Code Troubleshooting Procedures (Continued)