Filter
Top Products
Phaser 8400/8500/8550/8560 Color Printer Service Manual 8-25
Service Parts Disassembly
Transfix Camshaft (PL2.0.10)
1. Perform Steps 1 through 7 (remove Transfix Load Arms) of the Transfix
Load Module removal procedure (page 8-22).
2. Remove the Process Drive (page 8-43).
3. Slide the shaft to the right and make sure the bearing slides over to the
gear. Move the shaft down and slightly to the right, and then up and to the
left to remove it.
Drum Maintenance Camshaft (PL2.0.11)
Caution
Do not attempt to remove the Drum Maintenance Camshaft until the
bushing is completely disengaged from the right ground plane.
1. Remove the Drum Maintenance Pivot Plate (page 8-26).
2. Remove the Process Drive (page 8-43).
3. Slide the shaft to the right, free the bushing, and remove the shaft to the
right.
4. Carefully pry the bushing out of the right ground plane.
5. Rotate the left end of the shaft slightly toward the rear of the printer, lift the
shaft through the slot, and pull it out to the right through the large hole.
s8500-093
1
2
3
Transfix Camshaft
s8500-094
Bushing
Drum Maintenance Camshaft