Filter
Top Products
1. Movetheshippingcartontoastagingareaasclosetotheinstallationsiteaspossible.
2. Position the carton so that the arrows are pointing up.
3. Openthe top flaps on the shipping carton.
4. Pull out the packing material, which holds the line card in place.
5. Remove the line card from the antistatic bag.
6. Save the shipping carton and packing materials in case you need to move or ship
the line card later.
Figure 57: Unpacking a Line Card Used in an EX8200 Switch
Related Topics Packing a Line Card Used in an EX8200 Switch on page 259•
• Installing a Line Card in an EX8200 Switch on page 160
• 8-port SFP+ Line Card in an EX8200 Switch on page 30
• 40-port SFP+ Line Card in an EX8200 Switch on page 31
• 48-port SFP Line Card in an EX8200 Switch on page 33
• 48-port RJ-45 Line Card in an EX8200 Switch on page 34
Installing a Line Card in an EX8200 Switch
EX8200 switches have field-replaceable unit (FRU) line cards that can be installed in
the line card slots on the front of the switch chassis. The line cards are hot-insertable
and hot-removable: Youcan remove and replace them without powering off the switch
or disrupting switch functions.
Before you begin installing a line card in the switch:
•
EnsurethatyouhavetakenthenecessaryprecautionstopreventElectrostaticdischarge
(ESD) damage (see “Prevention of Electrostatic Discharge Damage on EX Series
Switches” on page 292).
•
If there are any transceivers installed in the line card, remove them before you install
the line card. For instructions on removing transceivers, see “Removing a Transceiver
from an EX Series Switch” on page 222.
Copyright ©2010,Juniper Networks,Inc.160
CompleteHardwareGuide forEX8208 EthernetSwitches