Filter
Top Products
7. Graspthe ejectorlevers andgentlyslidethe line cardhalfwayout ofthe chassis(see
Figure 89 on page 220 and Figure 90 on page 220).
Figure 89: Removing a Line Card with a 2-in. Ejector Lever
Ejector
levers
Captive
screw
EX8200-40XS
g020906
Figure 90: Removing a Line Card with a 4-in. Ejector Lever
See “Handling and Storing Line Cards in EX8200 Switches” on page 227.
CAUTION: Do not lift the line card by holding the ejector levers on the faceplate or the
edge connectors. The levers cannot support the weight of the line card. Lifting the line
cardsby the levers might bend them. Bent levers prevent the line cards from being
properly seated in the chassis.
CAUTION: Do not stackline cards on top of one another or on top of any other
component. Place each line card separately in the antistatic bag or on the antistatic
mat placed on a flat, stable surface.
CAUTION: The line cards in EX8200 switches weigh more than 10 lb (4.5 kg). Be
prepared to support the full weight as you slide the line card out of the chassis.
8. Place one hand around the faceplate of the line card and the other hand under the
line card to support it. Taking care not to touch line card components, pins, leads,
or solder connections, gently slide the line card completely out of the chassis and
place it in an antistatic bag or on its own antistatic mat placed on a flat, stable
surface.
Copyright ©2010,Juniper Networks,Inc.220
CompleteHardwareGuide forEX8208 EthernetSwitches