Filter
Top Products
This topic describes:
1. Packing an EX8200 Switch on page 255
2. Packing EX8200 Switch Components for Shipping on page 258
Packing an EX8200 Switch
If you need to transport the switch to another location or return the switch to Juniper
Networks,youneedtopacktheswitchsecurelyinitsoriginalpackagingtopreventdamage
during transportation.
Before you pack the switch:
1. Power off the switch. See “Powering Off an EX8200 Switch” on page 199.
2. Remove all wires, plugs, and power cords from the switch.
3. Removealllinecardsandpackthemintheiroriginalshippingcontainers.See“Packing
a Line Card Used in an EX8200 Switch” on page 259.
4. Install cover panels over blank slots.
Leave components that came installed in the chassis in the chassis.
NOTE: Anyline cards ordered with the switch are shipped separately. Do not pack any
line cards with the switch.
Ensure that you have the following parts and tools available to pack the switch:
•
A7/16-in.or11-mmopen-endorsocketwrenchtoinstallthebracketboltsonthechassis
and shipping pallet
•
The original switch packing material (wooden pallet, cardboard box, accessory box
and its contents, foam padding, and brackets and bracket bolts for attaching the
chassis to the pallet)
•
Electrostatic discharge (ESD) grounding strap
The EX8200 switch is shipped in a cardboard box that has a two-layer wooden pallet
base with foam cushioning between the layers. The switch chassis is bolted tothe pallet
base with 4 pallet fasteners, 2 on each side of the chassis.
CAUTION: The switch is maximallyprotected inside the shipping box. Pack the switch
only in its original shipping box, securely bolted to the original wooden shipping pallet.
Do not pack the switch in anything except its original container or the switch might be
damaged in transit.
255Copyright©2010, JuniperNetworks, Inc.
Chapter16:ReturningtheSwitchorSwitch Components