Filter
Top Products
The line card has two status LEDs labeled ON and ST on the faceplate that indicate the
onlineandstatusinformationforthelinecard.See“LineCardLEDsinanEX8200Switch”
on page 35.
The 40-port SFP+ line card requires Junos OS for EX Series switches, Release 10.3 or
later.
The line card is shipped with 40 dust covers (in an accessory bag).
Related Topics 8-port SFP+ Line Card in an EX8200 Switch on page 30•
• 48-port SFP Line Card in an EX8200 Switch on page 33
• 48-port RJ-45 Line Card in an EX8200 Switch on page 34
• Optical Interface Support in EX8200 Switches on page 60
• SFP+ Direct Attach Cables for EX Series Switches on page 83
• Troubleshooting CoS Schedulers on a 40-port SFP+ Line Card in an EX8200 Switch
48-port SFP Line Card in an EX8200 Switch
The line cards in EX8200 switches combine a Packet Forwarding Engine and Ethernet
interfaces on a single assembly. They are field-replaceable units (FRUs) that can be
installed in the line card slots on the front of the switch chassis. The line cards are
hot-insertable and hot-removable: You can remove and replace them without powering
off the switch or disrupting switch functions.
EX8200 switches use four types of line cards:
•
8-port SFP+ line card
•
40-port SFP+ line card
•
48-port SFP line card
•
48-port RJ-45 line card
You can use any combination of line cards in an EX8200 switch.
The48-portSFPlinecardforEX8200switches(seeFigure15onpage34)has481-gigabit
SFP ports on the faceplate in which you can install SFP transceivers. The line card is
shippedwith48dustcovers(intheaccessorybag).EachporthastwoLEDs.See“Network
Port LEDs in an EX8200 Switch” on page 37.
33Copyright©2010, JuniperNetworks, Inc.
Chapter2:ComponentDescriptions