Filter
Top Products
Figure 74: Connecting an EX Series Switch Directly to a Management
Console
g020570
Laptop CPU
ToConsole port
(on the switch)
Related Topics ConnectinganEXSeriesSwitchtoaNetworkforOut-of-BandManagementonpage187•
• Console Port Connector Pinout Information for an EX Series Switch on page 58
• Cables Connecting the EX8200 Switch to Management Devices on page 105
Connecting an EX Series Switch to a Modem
You canconnectanEX Seriesswitchtoamodemthroughtheconsoleporton theswitch.
Before you connect the switch to a modem:
•
Perform the initial setup and configuration of the switch. See “Connecting and
Configuring an EX Series Switch (CLI Procedure)” on page 190 or “Connecting and
Configuring an EX Series Switch (J-WebProcedure)” on page 192.
Ensurethatyouhavethefollowingpartsavailablebeforeyoubegintoconnecttheswitch
to the modem:
•
A modem (not provided)
•
A desktop or notebook computer (not provided)
•
An RJ-45 to DB-9 adapter and an Ethernet cable (provided)
•
A phone cable (not provided)
•
IfyourcomputerdoesnothaveaDB-9maleconnectorpin,aUSBtoDB-9maleadapter
(not provided)
•
An adapter to connect the RS-232 DB-25 connector on the modem to the RJ-45 to
DB-9 adapter on the switch (not provided)
This topic describes:
1. Setting the Serial Console Speed for the Switch on page 183
2. Configuring the Modem on page 184
3. Connecting the Modem to the Console Port on page 185
Setting the Serial Console Speed for the Switch
Before you can connect the switch to a modem, the switch’s serial console speed must
be set to 115200 baud.
183Copyright©2010, JuniperNetworks, Inc.
Chapter10:Connectingthe Switch