Filter
Top Products
WARNING: Do not look directly into a fiber-optic transceiveror into the ends of
fiber-optic cables. Fiber-optic transceivers and fiber-optic cables connected to
transceiversemit laser light that can damage your eyes.
Figure 62: Installing a Transceiver in an EX Series Switch
Related Topics Removing a Transceiver from an EX Series Switch on page 222•
• Connecting a Fiber-Optic Cable to an EX Series Switch on page 165
• Optical Interface Support in EX2200 Switches
• Optical Interface Support in EX3200 and EX4200 Switches
• Optical Interface Support in EX4500 Switches
• Optical Interface Support in EX8200 Switches on page 60
Connecting a Fiber-Optic Cable to an EX Series Switch
EX Series switches have field-replaceable unit (FRU) optical transceivers to which you
can connect fiber-optic cables.
Before you begin connecting a fiber-optic cable to an optical transceiver installed in an
EXSeriesswitch,ensurethatyouhavetakenthenecessaryprecautionsforsafe handling
of lasers (see “Laser and LED Safety Guidelines and Warnings for EX Series Switches”
on page 269).
To connect a fiber-optic cable to an optical transceiver installed in an EX Series switch:
WARNING: Do not look directly into a fiber-optic transceiveror into the ends of
fiber-optic cables. Fiber-optic transceivers and fiber-optic cables connected to
transceiversemit laser light that can damage your eyes.
1. If the fiber-optic cable connector is covered by a rubber safety cap, remove the cap.
Save the cap.
2. Remove the rubber safety cap from the optical transceiver. Save the cap.
3. Insert the cable connector into the optical transceiver (see Figure 63 on page 166).
165Copyright©2010,Juniper Networks,Inc.
Chapter9:Installing SwitchComponents