Filter
Top Products
Table 7: LCD Panel Menu Options for the EX8200 Switch (continued)
DescriptionMenu
TheMaintenancemenu hasthe following options:
•
SYSTEM HALT?—Chooseone of the following:
•
Press Enterto haltthe masterSRE modulein an EX8208 switchor to haltthe master RE modulein an
EX8216 switch. PressEnter again to confirmthe halt.
In a baseconfigurationswitch,the masterSRE or RE modulewill be gracefullyhaltedbut not powered
off.PressEnter on yourmanagementdeviceor powercyclethe switchtobring the switchback up.
In a redundantconfiguration,the backup SRE or RE moduletakesovermastership when the master SRE
or RE moduleis halted.Tocompletelyhalt the switch, use the requestsystemhaltother-routing-engine
CLI commandto haltthe backupSRE or RE module before haltingthe master SRE or RE module.Press
Enteron your managementdeviceor powercycle the switchtobring the switchback up.
See“EX8208 Switch Configurations”on page6 or EX8216 Switch Configurationsfor information on
configurationtypes.
•
Press Menu togo tothe nextoption in the Maintenancemenu.
•
SYSTEM REBOOT?—Chooseone of the following:
•
Press Enterto rebootthe masterSRE or RE module.PressEnter againtoconfirm the reboot.
•
Press Menu togo tothe nextoption in the Maintenancemenu.
•
LOADRESCUE?—Chooseone of the following:
•
Press Enterto rollback the switchto the previousvalidconfiguration. Press Enter againtoconfirm the
rollback.
•
Press Menu togo tothe nextoption in the Maintenancemenu.
•
FACTORYDEFAULT?—Choose one of the following:
•
Press Enterto restore the switch tothe factory default configuration.PressEnter again to confirmthe
restoration. TheLCDflashes a success or failure message and returnsto the Idlemenu.
•
Press Menu togo tothe nextoption in the Maintenancemenu.
•
ENTER EZSETUP?—Chooseone of the following:
•
Press Enterto launchEZSetup. PressEnteragain toconfirm the launch.
EZSetupconfiguresDHCPandenablestheJ-Webuser interfaceontheswitch.TheLCDflashesa success
or failuremessageforapproximately 10 secondsand returnsto the Idlemenu.
•
Press Menu togo tothe nextoption in the Maintenancemenu.
NOTE: You can use the EZSetupoption onlyif the switchis in the factory defaultconfiguration.
•
EXIT MAINT MENU?—Chooseone of the following:
•
Press Enterto exitthe Maintenancemenu.
•
Press Menu toreturn tothe SYSTEM HALToption.
IfyoudonotwantuserstouseMaintenancemenuoptions,disabletheentiremenuorindividualmenuoptions.
SeeConfiguringthe LCDPanelon EX SeriesSwitches (CLIProcedure).
Maintenance
You can view the informationabout the LCD panel in EX8200 switches by executing the
command showchassis hardware. It shows the version, part number, serial number, and
description of the LCD panel.
Related Topics Chassis Status LEDs in an EX8200 Switch on page 22•
• Field-Replaceable Units in an EX8208 Switch on page 23
• Field-Replaceable Units in an EX8216 Switch
21Copyright©2010, JuniperNetworks, Inc.
Chapter2:ComponentDescriptions