• See Rear Panel of an EX3200 Switch for port location.
• See Rear Panel of an EX4200 Switch for port location.
• See Front Panel of an EX4500 Switch for port location.
• See Switch Fabricand RoutingEngine (SRE) Modulein an EX8208 Switchon page24
for port location.
• See Routing Engine (RE) Module in an EX8216 Switch for port location.
• Connecting an EX Series Switch to a Management Console on page 181
Management Port Connector Pinout Information for an EX8200 Switch
The management port on an EX8200 switch uses an RJ-45 connector to connect to a
management device for out-of-band management.
The port uses an autosensing RJ-45 connector to support a 10/100/1000Base-T
connection.TwoLEDsontheportindicatelink/activityontheportandtheadministrative
status of the port. See “Management Port LEDs in EX8200 Switches” on page 27.
Table 30 on page 59 provides the pinout information of the RJ-45 connector. An RJ-45
cable, with a connector attached, is supplied with the switch.
Table 30: Management Port Connector Pinout Information for EX8200 Switches
DescriptionSignalPin
Transmit/receive datapair 1TRP1+1
Transmit/receive datapair 1TRP1-2
Transmit/receive datapair 2TRP2+3
Transmit/receive datapair 3TRP3+4
Transmit/receive datapair 3TRP3-5
Transmit/receive datapair 2TRP2-6
Transmit/receive datapair 4TRP4+7
Transmit/receive datapair 4TRP4-8
Related Topics SeeSwitch Fabricand Routing Engine (SRE) Module in an EX8208 Switch on page24
for port location.
•
• See Routing Engine (RE) Module in an EX8216 Switch for port location.
• ConnectinganEXSeriesSwitchtoaNetworkforOut-of-BandManagementonpage187
59Copyright©2010,Juniper Networks,Inc.
Chapter3:ComponentSpecifications