The maintenance mode allows you to cycle through options for configuring and
troubleshooting the switch:
•
System halt
•
Reboot system
•
Load rescue configuration
•
Revert to factory configuration
•
EZSetup
LCD Panel Menus
The LCD has three menus: Idle, Status, and Maintenance. In each of these menus, line
one of the LCD panel displays the hostname of the switch. Toggle between the LCD
menus by pressingthe Menu button.Navigatethrough the menu options by pressingthe
Enter button.
Table 7 on page 19 describes the LCD menu options.
Table 7: LCD Panel Menu Options for the EX8200 Switch
DescriptionMenu
In the Idlemenu:
•
Press Enterto cycle throughthe Status LED modes, which areport statusindicators:
•
ADM (enabled/disabled)
•
SPD (speed)
•
DPX (duplex)
See“NetworkPortLEDs in an EX8200 Switch” on page37 forinformationon the Status LED.
•
Press Menu toexit the Idlemenu and go tothe Status menu.
Idle
19Copyright©2010,Juniper Networks, Inc.
Chapter2:ComponentDescriptions