Filter
Top Products
CHAPTER 15
Troubleshooting Switch Components
•
Troubleshooting Line Card Installation on EX8200 Switches on page 237
Troubleshooting Line Card Installation on EX8200 Switches
Problem The ON LED on a line card does not blink in green or is not lit steadily after the line card
is installed in an EX8200 switch.
Cause One or both of these has caused these problems:
• The switchdoes not have sufficient power to power the line card while maintaining its
N+1 or N+N power configuration.
• The line card is not seated correctly in the slot in the switch chassis.
Solution If the ON LED does not blink in green:1.
• Ensure the switch has sufficient power to power the line card while maintaining
its N+1 or N+N power configuration:
• Todeterminethepowerrequirementsofthelinecard,see“PowerRequirements
forEX8208SwitchComponents”onpage111orPowerRequirementsforEX8216
Switch Components.
• Todetermine whether the switch has enough power available for the line card,
usetheshowchassispower-budget-statisticscommandif yourswitchisrunning
Junos OS Release 10.2 or later.If your switch is running Junos OS Release 10.1 or
earlier,see“CalculatingPowerRequirementsforanEX8208Switch”onpage114
or Calculating Power Requirements for an EX8216 Switch to calculate the
available power.
• If theON LEDdoes not blinkstill, remove the line card (see “Removing a Line Card
froman EX8200 Switch” on page218) and reinstallthe line card (see“Installing a
Line Card in an EX8200 Switch” on page 160).
2. Ifthe ON LED blinks in green, but is not lit steadily, tighten the captive screws on the
faceplate of the line card.
Related Topics • 8-port SFP+ Line Card in an EX8200 Switch on page 30
237Copyright©2010,Juniper Networks,Inc.