Filter
Top Products
Related Topics Connecting an EX Series Switch to a Management Console on page 181•
• Console Port Connector Pinout Information for an EX Series Switch on page 58
Connecting an EX Series Switch to a Network for Out-of-Band Management
YoucanmonitorandmanageanEXSeriesswitchusingadedicatedmanagementchannel.
EX Series switches have a management port with an RJ-45 connector for out-of-band
management. Use the management port to connect the EX Series switch to the
management device.
Ensure that you have an Ethernet cable with an RJ-45 connector available. One such
cable is provided with the switch. Figure 76 on page 187 shows the RJ-45 connector of
the Ethernet cable supplied with the switch.
Figure 76: Ethernet Cable Connector
To connect an EX Series switch to a network for out-of-band management (see Figure
77 on page 188):
1. Connect one end of the Ethernet cable to the management port (labeled MGMT)
on the EX Series switch.
For the location of the MGMT port on different EX Series switches:
•
See Rear Panel of an EX2200 Switch.
•
See Rear Panel of an EX3200 Switch.
•
See Rear Panel of an EX4200 Switch.
•
See Front Panel of an EX4500 Switch.
•
See “Switch Fabric and Routing Engine (SRE) Module in an EX8208 Switch” on
page 24.
•
See Routing Engine (RE) Module in an EX8216 Switch.
2. Connect the other end of the Ethernet cable to the management device.
187Copyright©2010,Juniper Networks,Inc.
Chapter10:Connectingthe Switch