Filter
Top Products
DEFINITY Enterprise Communications Server Release 8.2
Upgrades and Additions for R8r
555-233-115
Issue 1
April 2000
Adding or Removing Cabinet Hardware
6-72Add IP Interface Assembly
6
3. At the command prompt, type
ping
nnn.nnn.nnn.nnn
(which is the IP
address of your gateway).
■ If everything is configured correctly, the system responds with the
following message:
Reply from nnn.nnn.nnn.nnn: bytes=32 time<##ms
TTL=###
■ If no response, verify the IP address information and check the
connectivity, including the cabling.
■ I f all else fails, click on
Start > Settings > Control Panel >
Network
. Select the
Adapters
tab and highlight the [2] DEC
adapter.
■ Click
Properties > Change
.
■ From the Duplex Mode dropdown menu, select a setting that
matches the switch/hub that the TN802B connects to. For example,
10BaseT Full Duplex or 10BaseT No Link Test
4. At the command prompt, type
ping
nnn.nnn.nnn.nnn
(which is the IP
address of another external computer beyond the gateway).
■ If you have connectivity, the system responds with the following
message:
Reply from nnn.nnn.nnn.nnn: bytes=32 time<##ms
TTL=###
■ If no response, verify the IP address information and check the
connectivity, including the cabling. Consult your IP network
administrator.
5. Type
exit
and press
Enter.
Test the IP Interface Onboard LAN Connections
To test the onboard LAN connections, ping the IP Interface server and the
processor on the TN802B IP Interface.
1. Click
Start > Programs > Command Prompt
.
2. Type
ping
192.11.13.9
(which is the IP address of the internal IP Interface
server).
■ If everything is configured correctly, the system responds with the
following message:
Reply from 192.11.13.9: bytes=32 time<##ms TTL=###
■ If no response, verify the IP address information and check the
connectivity, including the cabling.