Filter
Top Products
DEFINITY Enterprise Communications Server Release 8.2
Upgrades and Additions for R8r
555-233-115
Issue 1
April 2000
Upgrading G3rV2, V3, V4 to R8r and Adding Memory
1-12Upgrade the software and hardware
1
Install the Circuit Packs
NOTE:
To properly seat a circuit pack, push firmly on the front of the faceplate until
the latch reaches the bottom rail of the carrier. Then close the latch until it is
fully engaged.
1. Insert the TN1650B memory circuit pack in memory slot 3.
NOTE:
If a high or critical reliability system, install the TN1650B at the same
time as the optical drive. Note that adding memory to the standby
SPE causes an error because the memory number between the
standby and active carriers does not match.
2. Insert the UN332C circuit pack into the MSSNET slot.
3. Replace the blank faceplate next to the MSSNET circuit pack.
4. Insert the TN2211 optical drive (Figure 1-1
) into the right most TAPE DRIVE
slot. It only takes up 2 slots.
5. Place a blank faceplate over the left most TAPE DRIVE slot.
Figure 1-1. TN2211 Optical Drive
Red
Green
Yellow
fpdf2211 KLC 010600
TN2211 OPTICAL DRIVE