Lucent Technologies 555-233-115 Server User Manual


 
DEFINITY Enterprise Communications Server Release 8.2
Upgrades and Additions for R8r
555-233-115
Issue 1
April 2000
Adding or Removing Cabinet Hardware
6-109Add a Switch Node Carrier (High or Critical Reliability)
6
Save Translations
1. Log in at the management terminal.
2. If the system is high- or critical-reliability, type
status spe
and press
Enter
to verify that the standby SPE is refreshed and that the standby disk is in
service.
3. Type
save translation [spe-a
or
both] disk
and press
Enter. This
command instructs the system to take all translation information in
memory and write it to the disk(s).
4. If the system contains a TN750/B Announcement circuit pack, type
display announcements
and press
Enter.
5. If administered recorded announcements are listed, type
list
configuration software-version
and press
Enter. Check screen 2 to find
out when the announcements were last saved. Save the current
announcements by typing
save announcements disk
and pressing
Enter.
6. Type
backup disk [spe-a
or
both]
and press
Enter. This instructs the
system to backup the current information on disk to the system tape(s).
7. Update backup tape(s), if required.
Shut Down DEFINITY LAN Gateway System
If a DEFINITY LAN Gateway system resides in the control cabinet to be
upgraded, prepare to shut down the DEFINITY LAN Gateway assembly and
allow the disk to completely spin down.
!
CAUTION:
Make sure that you save the system parameters if you plan to reuse the
current system.
!
WARNING:
Neglecting to shut down a DEFINITY LAN Gateway assembly before
powering down the system cabinet where it resides can damage the LAN
Gateway disk.
1. Log onto the DEFINITY LAN Gateway. See the
DEFINITY Communications
System Generic 3 Installation, Administration and Maintenance of
CallVisor ASAI over the DEFINITY LAN Gateway
.
2. When the main menu appears, select
Maintenance
.
3. Select
Reset System
from the
Maintenance
menu.
4. Select
Shutdown
from the
Reset System
menu.
5. Unseat the LAN Gateway assembly from its backplane connectors.