Filter
Top Products
DEFINITY Enterprise Communications Server Release 8.2
Upgrades and Additions for R8r
555-233-115
Issue 1
April 2000
Upgrading R5r/R6r/R7r to R8r without Adding Memory
2-11Upgrade the software and hardware
2
Remove the Circuit Packs
NOTE:
More detailed information on removing and adding circuit packs is in
Chapter 6, ‘‘Adding or Removing Cabinet Hardware’’
.
1. Remove the blank faceplate next to the MSSNET slot in the carrier.
2. Remove the UN332B circuit pack from the carrier and place it in antistatic
packing material.
3. Remove the TN1656 tape drive and place it in antistatic packing material.
Install the Circuit Packs
NOTE:
To properly seat a circuit pack, push firmly on the front of the faceplate until
the latch reaches the bottom rail of the carrier. Then close the latch until it is
fully engaged.
1. Insert the UN332C circuit pack into the MSSNET slot.
2. Replace the blank faceplate next to the MSSNET circuit pack.
3. Insert the TN2211 optical drive (
Figure 2-1
) into the right most TAPE DRIVE
slot. It only takes up 2 slots.
4. Place a blank faceplate over the left most TAPE DRIVE slot.
Figure 2-1. TN2211 Optical Drive
Red
Green
Yellow
fpdf2211 KLC 010600
TN2211 OPTICAL DRIVE