Filter
Top Products
DEFINITY Enterprise Communications Server Release 8.2
Upgrades and Additions for R8r
555-233-115
Issue 1
April 2000
Adding or Removing Cabinet Hardware
6-82Add a Control Carrier (Add Duplication)
6
3. Select
Reset System
from the
Maintenance
menu.
4. Select
Shutdown
from the
Reset System
menu.
5. Unseat the LAN Gateway assembly from its backplane connectors.
Shut Down DEFINITY AUDIX System
1. If a DEFINITY AUDIX resides in the PPN or an EPN (where PPN Port
Carrier B will be relocated), shut down the AUDIX and allow the disk to
completely spin down. Refer to
‘‘DEFINITY AUDIX Power Procedures’’ on
page 6-141.
!
WARNING:
Neglecting to shut down an AUDIX assembly before powering down
the system cabinet where it resides can damage the AUDIX disk.
2. Unseat the AUDIX assembly from its backplane connectors.
Power Down Port Networks
1. At the PPN, set the main circuit breaker to OFF.
2. At an EPN (where PPN port carrier B will be relocated), set the main circuit
breaker to OFF.
Remove Doors and Panels and Disconnect Cables
1. Remove the front door from the PPN cabinet.
2. With the cable retainer in front of you and the part number visible, locate
the slot that is almost vertical. (This slot is adjacent to the part number.)
Insert a flat blade screwdriver with a wide blade (1/4-inch recommended)
into the slot, and twist. The retainer snap opens easily so that the cable
can be removed.
3. At the cabinet, disconnect previously labeled cables associated with the
carrier to be removed.
4. Remove the back doors from the cabinet.