Filter
Top Products
CHAPTER 9 RESET FUNCTION
229
User’s Manual U10676EJ3V0UM
When RESET Signal Asserted
in Standby Mode
When RESET Signal Asserted
During Operation
Hardware
Basic inter-
val timer/
watchdog
timer
Timer
counter (T0)
Timer
counter (T1)
Table 9-1. Status of Each Hardware Unit After Reset (1/3)
Notes 1. If STOP mode is entered during an EEPROM write operation or if HALT mode is entered during a write
operation and then the RESET signal is input, this becomes undefined.
2. If the RESET signal is input during an EEPROM write operation, the address data becomes undefined.
Program counter (PC)
PSW Carry flag (CY)
Skip flags (SK0-SK2)
Interrupt status flags (IST0, IST1)
Bank enable flags (MBE, RBE)
Stack pointer (SP)
Stack bank select register (SBS)
Data memory (RAM)
Data memory (EEPROM)
EEPROM write control register (EWC)
General-purpose registers
(X, A, H, L, D, E, B, C)
Bank select registers (MBS, RBS)
Counter (BT)
Mode register (BTM)
Watchdog timer enable flag
(WDTM)
Counter (T0)
Modulo register (TMOD0)
Mode register (TM0)
TOE0, TOUT F/F
Counter (T1)
Modulo register (TMOD1)
Mode register (TM1)
TOE1, TOUT F/F
Sets lower 4 bits of program
memory address 0000H to
PC11-PC8, and contents of
address 0001H to PC7-PC0
Retained
0
0
Sets bit 6 of program memory
address 0000H to RBE and bit
7 to MBE
Undefined
1000B
Retained
Retained
Note 1
0
Retained
0, 0
Undefined
0
0
0
FFH
0
0, 0
0
FFH
0
0, 0
Same as left
Undefined
0
0
Same as left
Undefined
1000B
Undefined
Retained
Note 2
0
Undefined
0, 0
Undefined
0
0
0
FFH
0
0, 0
0
FFH
0
0, 0