3Com 5102B-EE Network Router User Manual


 
Management Commands 4 - 35
SET ALERT
Use the SET ALERT command to enable or disable the notification of an
alert statement (trap) from this Bridge Module to the designated trap
receiver (SNMP workstation).
Format
SET ALERT {alert type} {setting}
Parameters
{alert type} = authentication
change
hello
{setting} = enable
disable (default for all alert types)
Example
The following is an example of disabling the Hello alert, normally generated
when a new Bridge Module is installed in the concentrator or when an
existing Bridge Module is reset.
OEBM> set alert hello enable [ENTER]
Alert HELLO set to ENABLE
Example
The following is an example of enabling the Change alert for any
configuration change made to the Bridge Module.
OEBM> set alert change enable [ENTER]
Alert CHANGE set to ENABLE
Description
You can have the Bridge Module send an alert (trap) to the SNMP-based
management workstation (trap receiver) when any of the following three
system events happen: